Lace front cleaning and attachment ( hair replacement)

Here is some help for my hair wearers - that is how to clean your frontal part, or piece, when you need to .  You can use those directions for the whole system - either partial , or a full cap( whole head).

Lace Front re-attachment and cleanup

Ok. First is application instruction:
1. Comb clean  all hairs around the hairline of the system, Draw line with a pencil or a pressing teeth of a comb under the edge of the system , and then secure it with the metallic clips
2. Apply one coat above the line, make sure you paste some of the white pencil, so it's not visible too much . Let it dry clear( a few mins). Once it dries, you can re-apply  the second coat, and let it dry until is almost clear, do not wait for it to completely dry, then carefully position the piece, press model first , and align it towards the sides, one side at the time. Press gently with your fingertips along the application to secure the placement , and when you reach the other end- check for accuracy , and then press with the teeth of a comb. Check front edge if is all down, if not- touch-up with glue on a small stick.
  Removal:
1. Secure the forehead above your eyes with a cotton bandana, or a paper towel, then spray( or dab with a cotton ball)  a lace release( or 91% alcohol) all over the lace. Wait 30 sec and try to lift the lace. It should lift pretty easily, but if doesn't, just spray/dab and wait again. Once off, wipe the lace onto a piece of glossy paper( old magazines), that should take almost all the gook , if any. If the attachment is not fresh, try to wipe the gooky stuff from your forehead with glossy paper as well. If it doesn't come off, apply with a piece of cotton, or paper towel some  solvent over it, to soften it.
If there is any residue remaining onto the lace, apply small amount of the solvent onto it as well, and rub it between your fingers, then leave it aside, base down for 15-30 mins. After that apply small amount of shampoo directly onto the lace, and rub it with your fingers, then wet it with some water and gently rub it like u're washing a cloth. Rinse, if necessary repeat the shampoo , and after that, just roll it in a cotton towell to dry. After it dries, check for remaining spots from the glue, and just wipe them with the towel.
Before attaching it , make sure the lace is thoroughly dry.

Have fun!